Omni Systems, Inc. Mif2Go User's Guide, Version 55
> 16 Configuring DITA maps > 16.5 Providing attributes for bookmap wrapper elements
For situations in bookmap construction where
Mif2Go must provide a wrapper element that does not
directly correspond to a file in your FrameMaker book or to a component
specified in [DITABookmapFiles], unless you
supply values for navtitle, href,
type, format, scope,
and outputclass attributes, these attributes
are not present in the wrapper elements.
Mif2Go uses the settings described in this section only when wrappers are produced for a bookmap. In particular:
Part
as well as to Chapter, the navtitle
attribute applies to the Part tag.
MultiSeg,
and a wrapper is needed for one segment, the #topicID
is used as the file name.
StartSeg/EndSeg
group, the StartSeg file name specifies the
navtitle for the full wrapper.
href attribute
is to a topic that is not already in your FrameMaker .book,
and is provided as an introduction to the wrapped topics.
To specify a value for the navtitle
attribute:
; filename (without .ext) or component name = navtitle attribute
To specify a value for the outputclass
attribute:
; filename (without .ext) or component name = outputclass attribute
To specify a value for the href
attribute:
; filename (without .ext) or component name = href attribute
To specify a value for the type
attribute:
; filename (without .ext) or component name = type attribute
; for its wrapper element, for the specified href.
To specify a value for the format
attribute:
; filename (without .ext) or component name = format attribute
; for its wrapper element, for the specified href.
To specify a value for the scope
attribute:
; filename (without .ext) or component name = scope attribute
; for its wrapper element, for the specified href.